Mine road network
National Service Hotline
029-85212477
current location: home » Tech » Safety and environmental protection » text

Interpretation of eight kinds of signs in coal mines

Release date:2018-12-04  source:中南选矿网  Browse times:442
       
According to the general law of water permeability, the higher the water head in the water accumulation area, the greater the pressure. Therefore, when dealing with the water with high head water, it is necessary to adopt a method of turning the water into several sections for a period of time. Discharge water. The method of “segmented down-draining water” is now widely used to avoid the risk of the coal wall being crushed in one treatment. Practice has proved that all the old air, fault cracks, etc., which are connected to the upper and lower catchment areas of the ground and are mutually replenishing water sources, must have water. Therefore, when encountering old air, faults, cracks and boreholes with recharge water sources, Be vigilant and use careful waterproof measures to prevent water penetration. Mine permeable water has a harbinger in advance, and it can be identified according to eight different permeable symbols to see if it is permeable to water. (1) Moisture: Coal itself is impervious to water, but when it is subjected to a certain pressure of water, some water will still be immersed in the coal. Therefore, when the mining face is close to the water-storing area, local or large-area tidal phenomena will be discovered. This tidal phenomenon is not completely due to the proximity of the water area. When the floor rock formation is a permeable rock layer, Often the coal body has a moisture phenomenon. (2) Sweating: When the working surface is close to the water-storing area, it is like the sweating of people through the coal layer's bedding, joints and water passing through the coal wall and gathering into water balls. It must be pointed out here that the above two symbols, whether it is tidal or sweating, sometimes have illusions. The true and false of this tidal and sweating are often identified by the method of “shallow skinning”, which is the coal face that will swell or sweat. Strip a thin layer and observe if the newly exposed coal seams are also tidal. If it is tidal, it is a symbol of water permeability. (3) Running water or dripping water: This phenomenon is the result of further development of sweating, which proves that the distance between the working place and the stagnant water area is getting closer and closer. It also proves that the water-proof coal wall is getting softer and the water-tightness is getting worse. The ability to withstand pressure is getting less and less, and the overall situation is getting worse. At this time, we must be vigilant and step up. (4) Hanging red: This phenomenon is often caused by the phenomenon of running water. This phenomenon indicates that the water contains iron oxides, or sulphur iron minerals, etc., and the appearance of "hanging red" is generally considered to be a symbol close to the old water. (5) Air cooling: After the working surface is close to a large amount of water accumulation area, the temperature of the working surface is lowered and it feels cold. (6) Increased odor of hydrogen sulfide: Hydrogen disulfide gas is also a product of the old airspace. Therefore, when the working surface is close to the old empty area, sometimes the smell of hydrogen sulfide, the smell of pungent rotten eggs, can lead to rapid death. (7) Water Call: There are generally two kinds of sounds: one is: the sound of “嘶嘶”, which is like a deep thunder or a non-boiled sound, because the water level has changed or is being rocked. The result of the impact of the impact. (8) The bottom of the hole is soft or effluent. When using a water drill or a drill to probe the water, if the bottom of the hole is found to be soft and the drill cuttings are tidal, it means that the drill is reaching the water accumulation area. If the drilling continues, there is water. All of the above phenomena are close to the signs of the stagnant water area (or the old air). Special attention should be paid to taking measures to prevent the water from accumulating and causing harm. There are several ways to identify old empty water: use a finger to rub the water to stimulate the sense of lubrication; use the nose to smell rancid; sometimes mixed with the smell of rotten eggs, chewing with astringency; with decaying sediment and suspended matter When it is observed in detail, it will find that its transparency is low; when it is analyzed, the oxygen consumption is large, and the more oxygen is consumed when the organic matter is oxidized, the more organic matter is proved.

 
 
[ Techsearch ]  [ Join in collection ]  [ Tell your friends ]  [ Print this article ]  [ Illegal reporting ]  [ close window ]

 

 
Recommend Tech
Click rank
cancel

Thank you for your support, I will continue to work hard.!

Sweep code support
Say as much as you like.

openAlipayIf you sweep, you can get a reward for sweeping yards.

Website Homepage

About Us

Contact

Use Agreement

Copyright privacy

Sitemap

Service Items

Member Service

Advertising Services

Website Message

Four Privileges

Payment Method

Apple APP Download
Android App Download
Mining Club
Contact Us

029-85212477

We are always waiting for your visit!

| ICP business license: Shaanxi ICP No. 15507745